AT9924t

From RARForge
Jump to navigation Jump to search

commands[edit]

HELP[edit]

  • my help was not set - luckily there was a .hlp file under 'show files' so I set it..

<source lang=bash> show file

Filename Device Size Created Locks


89-266.rez flash 4179688 13-Apr-2010 16:13:00 0 89-266a.hlp flash 148723 13-Apr-2010 16:14:45 0 </source> <source lang=bash>

  1. set HELP

set help=89-266a.hlp </source> <source lang=bash> help

       AT-9900 Series Switches          HELP v2.6.6 Rev A, 08-Nov-2004


 Help is available on the following topics:
   HELP APPLETALK            Appletalk commands
   HELP ASYNCHRONOUS         Async ports, TTY
   HELP BGP                  BGP version 4 routing protocol commands
   HELP BOOTP                BootP relay commands
   HELP DHCP                 DHCP server commands
   HELP DHCP6                DHCP6 commands
   HELP DVMRP                Distance Vector Multicast Routing commands
 ...

</source>

IP Config - Route[edit]

<source lang=bash> enable ip add ip int=vlan1209 ip=10.69.1.249 mask=255.255.255.0 set ip int=vlan1209 mul=on add ip rou=0.0.0.0 mask=0.0.0.0 int=vlan1209 next=10.69.1.1 </source>

Save Config[edit]

<source lang=bash> create conf=config.cfg

  1. to set the config for boot, this only needs to be done once.

set conf=config.cfg </source> <source lang=bash>

  1. I created an alias, to save the config easier

add alias="write" string="create con=config.cfg"

  1. now we just type 'write to save the config'

write </source>

VLANs[edit]

Creating[edit]

<source lang=bash> create vlan="external" vid=1208 create vlan="private" vid=1209 create vlan="drbd" vid=1300 </source>

Adding to Ports[edit]

<source lang=bash> add vlan="1300" port=21-24 add vlan="1209" port=9-11 frame=tagged </source>

SNMP[edit]

<source lang=bash> enable snmp create snmp community=<private> access=write open=on add snmp community=<private> traphost=10.69.1.9 </source>

NTP[edit]

<source lang=bash> enable ntp set ntp utc=-07:00:00 add ntp peer=<ip of NTP server> </source>