Why Is A Cam Lock Replacement Necessary
E1016 cam lock cross connection is the most common type of lock repair. Cam-tamp has an O-ring over a threaded drain pipe on both sides of the lock. The O-ring is then clamped or locked to the cam-tamp surface.
The threads on the cam-tamp are very small and can be easily scrapped by a sharp tool. So it is important that the lock has been prepared before working on it. One can take off the spring base plate on both sides of the lock and use pliers to strip off the old spring. One should then tap the lock slightly with a hammer so that one can work on the lock in a better position.
Once the old spring is removed one can replace it with the new one. The threads on the new spring are also very small. They can get stripped off due to compression of the lock when the lock is closed and opened during the unlocking process. The threads on the new spring are sixteenth inch long. They will not be able to reach as far into the lock as the older spring threads, but they are larger than one-half inch threads on the old spring.
A screwdriver or a flat head screwdriver is used to remove the two-inch drain pipe from the side of the cam lock. The new drain pipe should be attached to the end of the lock assembly. This allows one to work on the lock assembly from all sides without getting someone injured. One should bend the threads on the new drain pipe to match the threads on the cam lock. Here's more about www.Shunchengvalve.com review our own web site. One should make sure that the threads on the cam lock match the threads on the pipes to which the lock has been attached.
After fixing the cam lock, a rubber washer and some plumbers putty need to be applied to the inside of the lock to keep the lock in place and to provide a seal. A washer acts like a valve and seals the gap between the cam and the lock body. Plumber's putty is used as a layer between the lock and the drain pipe to keep the lock in place and also as an insulator. When using plumbers' putty, it is best to use the smallest quantity possible so that the lock does not come undone.
Once the lock has been properly fixed, one has to consider the water seal. Most lock repair kits do not include any water seal. It is necessary to add water seal to the water system so that the pump can fill up the lock and prevent any leakage. Water seal is usually a rubberized tape, but a better option would be to use some plastic pipes instead of rubber tubes. Plastic pipes are not only easier to install, but they also have a smaller chance of leaking. It takes a while to test if the lock has leaks, and for this reason you should always add water seal to prevent any breakage of the lock.
The lock repair kit also consists of different tools that you may find useful. Among these are lock picks, chisels, a knife, screwdrivers and even an electrical tape measure. These tools can be used to fully open or shut the lock to improve the chances of penetrating it and liberating the contents of your car. The locksmith can also advise you on how to perform a basic inspection of your lock. This will help you determine what is inside your car before you open it to identify potential risks.
If you are looking to get your hands on the best deal when it comes to buying a lock and are not interested in risking a broken lock, then you should opt to buy from a professional lock repair expert. It is best to contact a professional lock repair company in the case of a malfunctioning lock. The technicians can even help you choose a lock that will fit your needs best without compromising one's security. There are many companies that specialize in offering services at competitive rates and you can find one near your locality by conducting a thorough online search. These companies employ qualified technicians who are trained to handle all sorts of locks and one of them might just fit your needs perfectly.